Lubricant > Dry type (bôi trơn > Bôi trơn dạng khô)


Cơ quan việt nam : Qualiserv (Vietnam) Co.,Ltd. (bấm vào đây)

PIN CARE NEXT

This product is dry type lubricant with thin film. It is the best lubricant for applies to the shaping part like the ejector pin, slide parts, etc. that you are worry about the stain.

Also, it can be used under severe temperature conditions.

Feature Ingredients Regulation

・Sticky is few
・Pressure performance is excellent
・Sustained performance is good
・Heat-resistant 300℃

Special synthetic oil
Lubricating additives
Hydrocarbon solvent
LPG

 

Package:420ml×6 or 24cans/box



J1

This product is dry lubricant with contains PTFE, it is suitable for applied to the moveable part that do not want to be dirty.

To compare with PINCARE NEXT, effectiveness is weaker than, but the stickiness and blot is very little.

Feature Ingredients Regulation

・Sticky is few
・Few bad influence to plastics

PTFE
Petrolatum
Additive
Hydrocarbon solvent
LPG

 

Package:420ml×12 or 48cans/box


MOULD HELPER

This product is dry type lubricant with contains PTFE. So, the stickiness and blot is very little.In additional, it contains anti-rust component, so able to applied to the moveable part without dirty.
It has hardly effect on plastic.

Feature Ingredients Regulation

・Sticky is few
・Few bad influence to plastics
・Containing anticorrosive

PTFE
Petrolatum
Additive
Hydrocarbon solvent
LPG

 

Package:420ml×12 or 48cans/box


WHITE LUB SPRAY

This product is a spray of White Lub F.
It is suitable for applied to the moveable part that do not want to be dirty.

Feature Ingredients Regulation

・Chlorine Free, Non-Flammable
・Highly safe and non-toxic
・Ozon depleting potential 0

Fluorine oil
PTFE
Fluorine solvent
LPG

 

Package:420ml×6・48cans/box 



FLUO LUB

A dry film lubricant in which a fluoropolymer is dispersed in a fluorine-based solvent. Ideal for lubrication of areas such as die ejector pins and slides where oil adhesion is not desired.
It can also be used for the following purposes.
○Lubrication of sliding parts and gears of electronic devices, office automation equipment, home appliances, automobile interior parts, etc.
○Prevention of squeaking noise at parts joint
○Lubrication of various bearings
○Lubrication for contact switches: Does not generate insulating material due to high temperature and discharge found in Si
○Masking: Masking for film capacitor deposition
○Sealant: Sealant with inert fluid
○Excellent in optical properties with low refraction such as antifouling coating and fingerprint prevention
○Mold release when molding various resins and rubber

Feature Ingredients Regulation

・Dry lubrication film
・No impact on rubber/plastic
・Non-flammable and highly safe

Fluoropolymer
Fluorine solvent

 

Package:100ml