| P R O D U C T S | T Y P E |
| ■ MOLD RELEASE AGENT | ●GENERAL ●HEAT RESISTANT |
| ■ ANTI RUST AGENT | ●SHORT TERM ●MIDDLE TERM ●LONG TERM |
| ■ CLEANING AGENT | ●GENERAL ●STORONG ●GAS & TAR REMOVER |
| ■ LUBRICANT AGENT | ●DRY ●OIL ●GREASE ●LIQUID |
| ■ SURFACE TREATMENT | ●SURFACE TREATMENT ●ANTI STATIC ●COATING |
| ■ OTHER / OEM ODM | ●OTHER ●OEM ODM |
IP CLEANER
This product is the spray adhered to the mold resin gas stains can be easily removed.
This product takes into consideration various laws and regulations and the effects on the human body.
| Regulation | A or N/A | Regulation | A or N/A |
|---|---|---|---|
| Fire service low | 4-2 petroleum, water | ELV | N/A |
| 有規則 | N/A | RoHS2 | N/A |
| 特化則 | N/A | REACH | N/A |
| PRTR | N/A | GADSL | N/A |
| Feature | Ingredients | Regulation |
| High detergency Effective in removing gas from LCP, PA Various law regulations adaptation | Esters, Amides LPG | Class 2.1 UN1950 |
GAS TRICK GEL
This product is gas & tar removal agents spray. It is possible to easily remove the gas & tar of resin adhered to the mold.* Will not gel at temperatures above 50 ° C, fluid performance is fine. Please directly spray on gas or tar. Then, shot loss after leave for 4-5 minutes, and remove by cleaning agents.
| Feature | Ingredients | Regulation |
| High detergency Low smell Gel type | MNP, Mixed solvents Viscosity imparting agent Solvents, LPG | Class 2.1 UN1950 |
GAS TRICK
This product is the spray adhered to the mold resin gas stains can be easily removed.
The smell and toxicity are extremely few. Please directly spray on gas or tar, or spray on waist and swab on mold. Then, shot loss after leave for 4-5 minutes, and remove by air-blow or cleaning agents.
| Feature | Ingredients | Regulation |
| High detergency Low smell Big size (480) | MNP surfactant Alcohol, LPG | Class 2.1 UN1950 |
LIGHT STOPPER
This product is the spray adhered to the mold resin gas stains can be easily removed.
Please directly spray on gas or tar, or spray on waist and swab on mold. Then, shot loss after leave for 4-5 minutes, and remove by air-blow or cleaning agents.
| Feature | Ingredients | Regulation |
| High detergency | Cyclohexanon, Isoamylacetate Special solvent, LPG | Class 2.1 UN1950 |
MOULD FRESH
This product is effectiveness for peeling gas and/or tar off from mold, not only adaption resin, but also POM, PA66 or flame retardance like ABS, etc. It is a type safe for the human body. Apply to a little bit on gas and/or tar and wipe off with soft brush or cloth.
| Feature | Ingredients | Regulation |
| Physical hazards → N/A Health hazards → N/A Environmental hazards → N/A | Cyclohexanon, Isoamylacetate Special solvent, LPG | None |