PIN CARE NEXT

This product is dry type lubricant with thin film. It is the best lubricant for applies to the shaping part like the ejector pin, slide parts, etc. that you are worry about the stain.

Also, it can be used under severe temperature conditions.

J1

This product is dry lubricant with contains PTFE, it is suitable for applied to the moveable part that do not want to be dirty.

To compare with PINCARE NEXT, effectiveness is weaker than, but the stickiness and blot is very little.

MOULD HELPER

This product is dry type lubricant with contains PTFE. So, the stickiness and blot is very little.In additional, it contains anti-rust component, so able to applied to the moveable part without dirty.
It has hardly effect on plastic.

WHITE LUB SPRAY

This product is a spray of White Lub F.
It is suitable for applied to the moveable part that do not want to be dirty.

FLUO LUB

A dry film lubricant in which a fluoropolymer is dispersed in a fluorine-based solvent. Ideal for lubrication of areas such as die ejector pins and slides where oil adhesion is not desired.
It can also be used for the following purposes.
○Lubrication of sliding parts and gears of electronic devices, office automation equipment, home appliances, automobile interior parts, etc.
○Prevention of squeaking noise at parts joint
○Lubrication of various bearings
○Lubrication for contact switches: Does not generate insulating material due to high temperature and discharge found in Si
○Masking: Masking for film capacitor deposition
○Sealant: Sealant with inert fluid
○Excellent in optical properties with low refraction such as antifouling coating and fingerprint prevention
○Mold release when molding various resins and rubber